ENAR KAMEL Manual De Instrucciones página 25

11 INSTRUCTIONS TO ORDER SPARE PARTS
11.1 INSTRUCTIONS TO ORDER SPARE PARTS
1.
We recommend to include ITEM´S MANUFACTURE NUMBER.
2.
motor`s plastic frame. The transmission and pokers have the manufacture number engraved
outside.
3.
and consignee`s complete name.
4.
authorized returns must be sent carriage paid.
11.2 INSTRUCTIONS TO REQUEST WARRANTIES
1.
with manufacture`s defects. In no case the warranty will cover a malfunction due to improper usage
of the equipment.
2.
AUTHORIZED SHOP, always including the complete address and name of the consignee.
3.
requested, it will send a technical report.
The warranty will be void if any equipment has been previously handled by personnel outside of
ENARCO, S.A. or not authorized by it.
NB:
12 RECOMENDATIONS OF USE OF CONCRETE VIBRATOR
1.
among the reinforcement and the slump cone. It is recommendable to have an additional concrete
vibrator.
2.
means of safety and protection.
3.
thickness of every layer should be less than 50 cm, it is recomendable between 30 and 50 cm.
4.
the vibrator to push the concrete horizontally. The concrete vibrator should be introduced into the
mass at regular intervals. The interval should be from 8 to 10 times the diameter of the poker. See
the concrete in the process of vibrating to determine the field of action of the vibrator. This field
should be overlapped to avoid areas without vibrating. To obtain an optimum compacting of the
concrete, plunge it 10 cm into the precedent layer to assure a good adherence. The time in vibrating
the different layers should not be big to avoid cold joints. Do not push or force the vibrator into the
mass, it could be stuck in the reinforcements.
5.
and other factors. This time can be from 5 to 15 seconds after the immersion in each point. The time
is shorter for a fluid mass, a vibration in excess can produce segregation. It is considered the
concrete to be well vibrated when the surface around the poker is shiny and compact and there is
no more air bubbles, as well a change in the noise of the vibrator is produced. So much defects in
structures are produced due to perform the vibration in an unmethodically way and in a hurry.
6.
from the walls.
KAMEL - FLEXIBLE SHAFT AND POKERS
TDX1m, TDX1-5m, TDX2m, TDX3m, TDX4m, TDX5m, TDX6m
All spare parts request must include PART CODE NUMBER AS STATED IN THE PART LIST.
The identification plate with manufacture and model number is located in the top part of the
Let us to know the correct shipping instructions, including the wished route and the address
Do not return spare parts to the factory unless you have written permission from the same, all
The warranty is valid 1 year after the purchasing of the machine, The warranty will cover parts
In all warranty requests THE MACHINE MUST BE SENT TO ENARCO, S.A. or to an
The Technical Assistance Service will immediately notify you if it accepts the warranty and if
ENARCO, S.A., reserves the right to modify any part of this manual without prior notice.
Choose the type of vibrator adequate to the dimensions of the structure to vibrate, the distance
Before starting check that the concrete vibrator is in good use and it works correctly. Use the
Pour the concrete in the structure avoiding high heights. Try to pour levelled the concrete. The
Introduce the vibrator vertically in the concrete mass without moving it horizontally. Do not use
The time of vibration in each point depends on the type of the concrete, the size of the vibrator
Do not push or force the vibrator against the reinforcement. Keep a distance of 7 cm minimum
KAMEL - AX25, AX32, AX40, AX48, AX58
en
11