Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP AND OPERATION
1. Always wear gloves, eye protection and hard hat and safety
toed shoeswhen working with MAXISJAX
2. Use only a 1-1⁄2" or 2" rigid conduit or PJA-01/PJA-02 axle.
3. Place conduit or axle through wire reel. (Fig. 1)
4. Lift the Back Brace (9) by pulling up on the Maxis Lever (8),
rotate Front Arm (3) forward. Place Leveler Pin (11) in desired
set hole on Base Leg (1).
5. Raise Max Lever (8) so that it is pointing straight upward.
6. Open Upper Jaw (6).
7. Adjust height to clamp Jaws onto axle. Lift and place Leveler
Pin (11) into appropriate hole on the Base Leg and or adjust
Telescoping Arm (2).
8. Close Upper Jaw (6) on axle by replacing Hitch Pin (5). (Fig. 2)
9. For minor leveling and height adjustments use a wrench on the
Leveler Pin (11) to increase or decrease leg height. (Fig. 3)
10. To lift reels, push down on Max Lever (8) until lever is parallel
with Back Brace. (Fig. 4)
Fig. 1
Fig. 3
7
MAINTENANCE
®
.
SPECIFICATIONS
• Model# MJ-707
• Model# MJ-707
• Stock # 56-82-45-01
• Stock # 56-82-45-01
• Height –9.5"
• Height –9.5"
• Width – 36"
• Width – 36"
• Depth – 7.5"
• Depth – 7.5"
• Weight – 28.5lbs each or 57lbs per set
• Weight – 28.5lbs each or 57lbs per set
• Capacity – 1500lbs each or 3000lbs per set
• Capacity – 1500lbs each or 3000lbs per set
• Patent Number – US8276858 B1
• Patent Number – US8276858 B1
Fig. 2
Fig. 4
As needed, apply a little grease on the adjusting back brace
and the needle roller pin for easier lifting.
8
Publicidad
