Craftmade Nash NSH56 Guia De Instalacion página 9

9. Light Kit Assembly.
Remove 1 screw from motor plate on
underside of motor assembly and partially
loosen the other 2 screws. Align slotted
holes in center of fitter plate with loosened
screws in motor plate, allowing molex
connections from motor housing to come
through hole in middle of fitter plate. Twist
fitter plate to lock. Re-insert screw that was
just removed and securely tighten all 3
screws with a Phillips screwdriver.
Remove 4 screws from underside of fitter
plate.
Connect WHITE wire from motor housing to
WHITE wire from light kit fitter. Connect
BLACK wire from motor housing to BLACK
wire from light kit fitter. Be sure molex
connections snap together securely.
Carefully arrange wiring within light kit fitter.
Align holes in light kit fitter with holes in
fitter plate. Re-insert screws that were
previously removed and securely tighten
all 4 screws with a Phillips screwdriver.
Install four 4 watt LED bulbs (included).
Important: When replacing bulbs, please
allow bulb(s) to cool down before touching
them.
motor plate
fitter plate
bulb
page 9
motor housing
motor plate
screw
molex
connections
light kit fitter