Quick Tools QU861DW Instrucciones De Uso página 20

2.6.2. Operation
NOTE: check the parts in the package as the packing list. Some option parts may be not
in the package if do not order .
1. Put the unit on the flat workbench and select suitable nozzle to install (refer
to 9.2). After that, put the handle on the holder.
2. Insert the power plug into the power socket and then press the "POWER"
key. Switch on the power supply to the SMD rework system.
3. Take down the handle from the holder and the system comes into the work
state. When the temperature is stable, the temperature window displays
"Real Temp".
4. If in the unlocking state, it can set the temperature and the airflow.
(1) Click "TEMP" or "TEMP" key to set the temperature and click "AIR
" or "AIR " key to set the airflow (refer to the "temperature setting
& airflow setting")
(2) Select the working channel: After setting the temperature and
airflow, click CH1 (or CH2 or CH3) to save the setting data into channel
CH1 (or CH2 or CH3).
5. If in the locking state, it cannot set the temperature and the airflow and after
getting the power supply, the display shows "no" before into working.
6. After working, put back the handle on the holder. After that, the unit comes
into the cooling state and when cooling down to 100℃, the unit comes into
sleeping state.
7. If not use in a period of time, it must turn off the power switch and cut off
power supply.
CAUTION
The initial password is "000". At the initial state, the system is in the

unlocking state and it can set the parameters and select the channel.
For prolong the life of the heater and protect the safety of the chip, use as

low temperature as possible and as big airflow as possible if it can finish
the de-soldering work.
:
6
USER MANUAL