Publicidad
Idiomas disponibles
Idiomas disponibles
Preliminary check of the case
6
When all is well, use a clean fingertip to apply the special
silicone grease. And then spread it on the surface of the O-ring
until it is completely covered.
7
Close the waterproof case.
8
Dip the empty waterproof case into a water tank or a bathtub
and check for water leaks. For how to check it, see p.13.
If a water leak is detected ...
➀
Immediately take the waterproof case out of the water and dry it on the
outside.
➁
Make sure that there are no cracks in the waterproof case body. Check
the O-ring for attached foreign particles, flaws, cracks, odd shape, or
twisting, and for any foreign particles in the O-ring groove.
➂
When all is well, start over from the procedure on p.8.
If you find something wrong with the waterproof case, immediately stop
using it and contact your FUJIFILM dealer.
O-ring
Only use the special silicone grease
provided.
After applying the grease, check that
there is no sand or other substances
attached to the O-ring.
➀
Close the waterproof case and
turn the open/close knob in the
direction of the "CLOSE" arrow to
seal it.
➁
Lock the open/close knob.
EN-10
Publicidad
