Publicidad
Idiomas disponibles
Idiomas disponibles
Positioning the Digital Camera in the Waterproof Case
3
Insert the silica gel pack into the space underneath the bottom of
the camera.
Silica gel pack
4
Confirm the following before closing the waterproof case.
Silica gel pack
5
When all is well, close the waterproof case (p.10).
→
Check that the camera's "POWER" button and Mode dial can be correctly
operated using the controls on the housing.
To prevent water leaks
Any foreign particles attached to
the O-ring may cause a water leak.
Remove the foreign particles (see
p.22). If you cannot remove them,
replace the O-ring with a new one.
• No part of the silica gel pack is
• There is no dust, hair, or other
O-ring
• The camera is correctly seated and
EN-12
Make sure to insert the silica gel
pack correctly. If it is incompletely
inserted, it will prevent the O-ring
from acting as a seal, and water will
leak in.
protruding.
foreign particle on the O-ring, in
the O-ring groove, or on the edge
face of the waterproof case that
engages with the O-ring.
aligned in the waterproof case.
Hair
Lint
Sand
Publicidad
