Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARING VAC BAGS FROM A ROLL
1. Make sure the Vacuum Sealer is in the "OFF" position. Attach the Vacuum
Sealer to the power supply.
2. Turn the Vacuum Sealer "ON".
3. The "POWER" Light on the display, "POWER INDICATOR" Switch both will
illuminate and the Internal Cooling Fan will run.
4. Open the Vacuum Lid.
5. Cut a vacuum bag to the length you want from a roll.
6. Place either open end of the bag against the outer face of the Oval Vacuum
Chamber Seal in the Vacuum Chamber (not in the Vacuum Chamber).
7. Close the Vacuum Lid. The bag end should be sandwiched between the
Vacuum Lid Seal and Seal Bar Heating Element. Make sure there are no wrinkles
or creases in the bag in the sealing area.
8. Press and hold the Vacuum Lid Handle down. You may need to continue
holding the bag.
9. Press the "START" Button (this will engage the Pump and the Heating Element).
Press the Manual Seal Button to seal the vacuum bag.
10. Sealing is complete when the Vacuum Chamber releases after a 3 second
cooling period (the "COOL" Light will illuminate). The release is audible.
11. Open the Vacuum Lid and remove the bag. DO NOT try to open the Vacuum
Lid before the vacuum has released or unit damage may occur. Wait at least 20
seconds before sealing another bag to avoid overheating the unit.
12. Turn the Vacuum Sealer "OFF" and unplug the Power Cord when you are
done.
SERVICE INSTRUCTIONS
Electrical Shock Hazard. Before cleaning, assembling, or
w WARNING
disassembling the vacuum sealer, make sure the vacuum sealer
is unplugged.
Some parts of the Vacuum Sealer may need replacing after repeated use. A
Vacuum Sealer Maintenance Kit (Sold Separately Model No. 08-0501-W) may be
necessary for the Vacuum Sealer to properly function.
REPLACING THE OVAL VACUUM CHAMBER SEALS:
1. Turn "OFF" the Vacuum Sealer and remove the Power Cord from the electrical
outlet.
2. Make sure the unit is completely cool.
3. Open the Vacuum Lid.
4. Remove the Oval Vacuum Chamber Seal from the groove on the underside of
the Vacuum Lid.
5. Remove the Oval Vacuum Chamber Seal from the groove in the Plastic Vacuum
Chamber.
11
Publicidad
