Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
breakers
rated
for
conductors shall be a minimum of # 16 AWG copper wire
rated at 167 ℉ (75 ℃) or higher.
Never connect the ground wire to gas lines, or hot water
pipes, plumbing lines.
Do not use any extension cord or portable outlet device to
connect the dishwasher to a power supply.
These requirements must be met to prevent injury and
damage to the machine. Consult a qualified electrician if in
doubt.
E W
A
B
E W
•
A TOP VIEW
•
B FRONT VIEW
A properly-grounded, horizontally-mounted
electrical receptacle should be installed
E
according to this drawing.
Connections placement must be located on either side of
the cutout.
PLUMBING REQUIREMENTS
Installation must comply with all applicable plumbing codes.
Place the water supply and drain in an adjacent cabinet.
Connect the water supply to a hot water household supply
with an easily accessible shut-off valve between the supply
and the unit.
The edges of the opening must be smooth and round.
The water supply may be connected to the dishwasher with
either:
•
A metal braided hose
•
Copper tubing
15
amperes.
Electrical
E W
E W
supply
Use minimum ¾" O. D. copper tubing or metal braided
dishwasher supply line.
The dishwasher water inlet valve has an inlet coupling
thread dimension of ¾" – 11.5NH according to ASME
B1.20.7-1991. When buying a water inlet hose for your
dishwasher, please choose an inlet hose with thread
dimension compatible with the water inlet valve coupling
thread dimension (¾" - 11.5NH) of your dishwasher.
A high loop drain line is factory installed on the unit. Do not
remove the high loop clamp. If necessary, the drain tubing
can be extended by a maximum of 5" (1.5m). The
dishwasher drain hose must be installed with a drain loop
at least 28" (710) off the cabinet floor; otherwise, the
2"
50
dishwasher may not drain properly.
The temperatures required for soldering and sweating will
damage the dishwasher's water inlet valve, so if any such
operation is needed, keep the heat source min. 77/8"
(200mm) away from the dishwasher's water inlet valve.
There should not be any sharp bends in the water line that
may restrict the water flow.
Teflon tape or pipe thread compound must be used for
3 15/16"
sealing the connection. Before connecting the copper water
100
supply line to the dishwasher, flush it with hot water to clear
any foreign material.
Fig. 6
GARBAGE
DISPOSAL
•
A Air gap
•
B Drain hose
•
C Hose clamp
Purge the water supply prior to final connection to the unit.
This will remove any debris that may be present in the
tubing when installing the new water supply. Connect the
braided tubing from the unit to the household water supply
with the fitting provided.
Check all water supply fittings for leaks.
WITH AN AIR
WITHOUT AN
GAP
AIR GAP
A
B
C
11
Publicidad
