Bertazzoni DW24S3IPV Manual De Instalación página 20

INSTALLATION
2
3) As shown in Fig. 25 , Screws
21.5mm) are installed in positions III.
4) As shown in Fig. 25 , Wooden Door Fixing Strips are
installed in the positions shown in the figure.
NOTE
Before attaching the Wooden Door Fixing
Strips, remove the white papers from the
surface on both sides.
n
g
5) Before mounting the wooden door on the dishwasher,
mount the handle on the wooden door as in Fig. 26 .
6) The screws located on the wooden door are fitted to the
dishwasher at the discharges located on the door outer
sheet and are assembled as shown in Fig. 27 .
20
Fig. 24
5/32" x 27/32" (4mm x
n
g
Fig. 25
7) As shown in Fig. 27 , Screws
42.5mm) are installed in positions I, III and V.
NOTE
Before mounting the Screws
32" ( 4mm x 42.5mm); Screws in positions
I, III and V must be removed.
8) According to the weight of the assembled wooden door,
the balancing must be provided by the mechanism
shown in Fig. 28 .
• If the wooden door tends to open because the hinge
springs are adjusted for a heavier custom panel, the
mechanism must be turned in the direction of the white
arrow with a Phillips screwdriver.
• If the wooden door tends to close because the hinge
springs are adjusted for a lighter custom panel, the
mechanism must be turned in the direction of the white
arrow with a Phillips screwdriver.
NOTE
Minimum Phillips Screwdriver Diameter is
15/64" (6mm) for this application.
Fig. 26
5/32" x 53/32" ( 4mm x
5/32" x 53/
f
Fig. 27