Beurer LB 200 Instrucciones De Uso página 29

10. WHAT IF THERE ARE PROBLEMS?
Problem Possible cause
Mains plug not plugged in
Air humidifier Motor unit not seated properly on
will not turn on. water tank
Water tank is empty
The air humidifi- The desired target humidity has
er does not start already been reached or exceeded
Filter dirty
Insufficient air
flow
Blocked air inlet or outlet
Foreign object in air inlet or air outlet
The air humidifi-
Filter clogged
er is very noisy
Air humidifier is not standing on a
flat and level surface
The mains plug is not connected to
Control panel
the socket and/or not switched on
not illuminated/
no display.
The device is in NIGHT mode
Humidifier
starts at the
The device performs a measurement
lowest level
to verify that the target humidity is
even though the
still achieved.
target humidity
is reached.
The water tank
display lights
Air bubbles may have accumulated
up even though
at the tip of the water level sensor.
the water tank
is full.
No current
Water tank is empty. If the water
relative humidity
tank is empty, no humidity values
is shown on the
are shown.
display.
11. DISPOSAL
For environmental reasons, do not dispose of the device in household waste at the end of its service life.
Dispose of the device at a suitable local collection or recycling point in your country. Observe the local
regulations for material disposal. Dispose of the device in accordance with EC Directive Waste
Electrical and Electronic Equipment (WEEE). If you have any questions, please contact the local
Solution
Insert the mains plug into a suitable socket.
Check for correct positioning. There must
be no gap between the motor unit and the
water tank.
Fill the water tank
If you want a higher target humidity level,
set this using the target humidity button (see
section "7.2 Setting target humidity").
Clean the filter (see section "8.2 Cleaning
the filter") and/or descale (if necessary
replace).
Check air inlet/air outlet
Pull out the mains plug and remove foreign
bodies from the air inlet/air outlet.
Clean the filter (see section "8.2 Cleaning
the filter") and/or descale (if necessary
replace).
Place the air humidifier on a level and flat
surface.
Insert the mains plug into a suitable socket.
Use the fan speed button to select another
fan speed or mode.
Lift the filter holder incl. filter and water level
sensor upwards out of the water and reinsert
everything again.
Fill the water tank
29
-