Publicidad
Idiomas disponibles
Idiomas disponibles
FRONT PANEL
1. POWER SWITCH Device power button
2. POWER INDICATOR LED indicator that lights up when the device is in operation
3. SIGNAL INDICATOR LED indicator of safe operating range
4. CLIP INDICATOR LED indicator of the distortion status of the amplifier input signal.
To make the amplifier work in the safe state, lower the input gain level. Attention! the
amplifier does not make any correction to the distorted signal.
5. PROTECTION INDICATOR Protection status LED indicator. Turn off the amplifier and
check the causes. The amplifier is protected against over temperature, overload, short
circuit and DC.
6. OLED DISPLAY Displays the status of the DSP and set parameters.
7. CHANNEL VOLUME CONTROL Adjust the volume of the channel CH1, CH2.
8. MENU ENTER ENCODER Short press the encoder to display the DSP mode and version.
Long press the encoder for 2 seconds to enter the DSP internal setting parameters.
9. PC IN Use the USB cable to connect to the computer and open the software to adjust the
DSP parameters.
3
Publicidad
