3M M-153SG Instrucciones De Uso página 3

Requester: Farrel Allen
Creator: deZinnia_24105
File Name: 24105-01 M-Series knob-ratchet parts_PSD.ai
Structure #: Illustration
Date: 06/06/18
This artwork has been created as requested by 3M. 3M is responsible for the artwork
AS APPROVED and assumes full responsibility for its correctness.
Installing M-146SG Welding Knob and Pivot Kit and M-153SG Welding Shield
- To re-install the visor frame and welding knob and pivot kit, insert post into visor frame. The post should "click" into place.
- Install back plate into the headgear shell. When installing the "wind mill" pattern should be facing outwards and the "M-960" marking will be
located on the bottom of the plate. Install rounded edge first and slide completely into the slot (Fig. 2a). Gently push down on the back plate to
ensure it is flush to the bottom of the slot.
- Line up the visor frame over attachment slots and slide the metal spring clips into place. With the visor frame post and back plate engaged, the
visor frame should be in the fully open or fully closed position before the spring clip is installed (Fig. 2b).
- Install the cam and pivot post onto the visor frame post. Ensure the cam and pivot posts are being installed on the correct side of the headgear by
following the label on each cam and pivot post (L and R, for left and right as worn) (Fig 2c). Line up the screw holes on the cam and pivot post with
the pilot holes on the headgear shell. If this is a new installation locate the earmuff attachment points on the outside of the headgear shell (Fig. 2d).
Note on the M-400 and M-300 Series Headgear there are visible indents on the outside of the shell where the earmuffs attach. On the M-200, the
indents may not be as visible on the outside of the shell. Use a pen or a screwdriver to gently push on the screw attachment points to start the hole
(i.e. make an indent). This will make it easier to thread the screws into the shell. Install screws using an appropriately sized manual Phillips head
screwdriver, and hand tightening until secure (Fig. 2e).
- Hold the faceshield and headgear in place, and fit the welding shield over the cam and pivot posts. Secure each side of the welding shield by
screwing a spring loaded knob into a cam and pivot post on each side of the welding shield (Fig. 2f).
Fig. 1a
Printed Colors – Front:
Scale:
1 Inch
Fig. 1d
Fig. 2a
2
Fig. 1b
Fig. 1e
Fig. 2b
(English)
Fig. 1c
Fig. 1f
Fig. 2c