hillvert HT-WP-43A Manual De Instrucciones página 26

7. Fuel pump
8. Throttle lever
9. Plug for filling the pump
10. Water outlet
11. Water suction hole
12. Water drain plug
13. Screw clamps
14. Rubber seals
15. Hose clamps
16. Hose fittings
17. Suction filter
18. Ignition switch
3.2.
Preparation for operation
3.2.1 PLACING THE DEVICE
Use the device only in open spaces or well-ventilated places with ambient
temperatures not exceeding the range of 1-45
intake and the unit's gas exhaust. Keep the unit away from any hot surfaces. Always
operate the unit on a level, stable, fireproof and possibly dry surface and out of the
reach of children and persons with impaired mental, sensory and intellectual
functions. The work area of the unit should provide immediate access to the ignition
switch.
NOTE: The shorter the water suction hose, the better the performance, so place the
unit as close as possible to the water source to be pumped.
3.2.2 ASSEMBLY OF THE DEVICE
The machine itself is delivered almost ready to work. The hoses (not included in the
kit) need to be connected; the use of reinforced (reinforced) hoses is required - to
connect them, use the included accessories.
IMPORTANT: A suction filter must be installed at the end of the suction hose!
3.2.3 FUEL REFILLING
ATTENTION: the machine is powered by fuel, and its engine is designed only to burn
the fuel-oil mixture in proper proportions (see technical data tables). Using the
wrong fuel or without the addition of oil in the correct proportions will disturb the
engine's operation and may damage the machine! The set includes a container that
facilitates the preparation of the mixture.
To refuel the machine, unscrew the filler cap and pour fresh fuel-oil mixture into the
tank. Never exceed the level of approx. 25 mm below the filling opening:
o C. Do not obstruct the engine's air