Kicker 19421331 Instrucciones De Montaje página 3

Install the supplied threaded clips. Fig 4
Install the amplifier mounting bracket through the hole on the right side of the tailgate. While holding the
bracket at a slight angle, as indicated in Fig 5, work the right two mounting tabs and tilt switch through the
tailgate opening. Once the first two mounting tabs and tilt switch are inside the tailgate, rotate the bracket
clockwise and lower the left side of the bracket into the tailgate. Work the amplifier mounting bracket
under the factory wire harness and slide the bracket toward the left until the mounting holes line up with
the previously installed threaded clips. Re-install the 8mm nut and rubber plug removed earlier.
Note: Scan the QR code for amplifier bracket installation video.
front of vehicle
Install the provided M6 bolts to secure the front tabs of the
mounting bracket to the threaded clips. Re-install the wire
harness retainers removed earlier. Fig 6
Install the amplifier onto the amplifier bracket with the supplied
screws (short screws x 4). Fig. 7
Connect the amplifier harness to the amplifier and the four-pin connector to the tilt switch attached to the
amplifier bracket. Insert the plastic wire retainer into the holes provide in the amplifier bracket. Fig.7
Route the harness along the factory harness toward the passenger side of the tailgate.
Note: The tilt switch is designed to turn the speaker system off when the inner
tailgate is not in the fully down position. Failure to make this connection or
attempting to bypass this switch will result in a constant drain on the vehicle
battery. Likewise, any cutting, splicing or any other modifications made to the
amplifier harness will immediately void the warranty.
Fig 4
Fig 6
Fig 5
Fig 7
3