GRAPHITE 59G806 Instrucciones De Uso página 22

OPERATION OF THE TABLE EXTENSIONS
The table extensions (16) are located on both sides of the mitre saw base.
Unlock the locking knobs of the table extension (18) (fig. C).
Adjust the length of the table extensions.
Fasten the table extension using the locking knobs (18).
If needed, the tilting limiters can be used (17) to facilitate cutting to size.
OPERATION OF THE CUTTING DEPTH LIMITER
The cutting depth limiter can be used, when it is necessary to make a key in the workpiece. It is
performed by making a surface cut in the workpiece, when the disc does not operate at full possible
depth.
Lock the head locking lever (14).
Loosen the guide locking knob (12) and move the head backwards.
Tighten the guide locking knob (12).
Rotate the cutting depth limiter (10) to the setting for operation with limited cutting depth (fig. D).
Lower the extension arm and hold it in the lower position leaning against the cutting depth limiter.
Rotate (to the left or right) the cutting depth limiter bolt (11) (fig. D) to obtain the required depth of the
cutting disc.
Loosen the guide locking knob (12).
Make the cuts to the set depth.
In order to return to the full cutting depth, rotate the cutting depth limiter (10) to the position, in which
the cutting depth limiter bolt (11) does not contact the cutting depth limiter (10), once the extension
arm is lowered.
SETTING THE WORKING TABLE FOR MITRE CUTTING
The rotary extension arm allows for cutting the workpiece at any angle in the range of 45° left or right from the
perpendicular position.
Pull the head locking pin (9) and allow the extension arm to rise slowly to the upper position.
Loosen the working table locking knob (23).
Press and hold the automatic setting lever (22) and rotate the extension arm to the left or right so the
required value is shown on the angle scale of the working table (20).
Lock the working table locking knob (23).
The angle scale of the working table (20) has a number of marked positions, in which the preliminary
automatic setting of the rotary extension arm is made. This can be done only when the automatic setting
lever (22) is not held in the pressed position and it can be locked in factory-marked positions during the
rotation of the extension arm. These are the most frequently used mitre sawing angles (15º, 22,5º, 30º, 45º
to the left / right). The setting of any angle can be precisely adjusted using the angle scale of the working
table (20) with the scale every single degree. Even though the scale is accurate enough for a majority of
performed tasks, it is recommended to double-check the cutting angle with a protractor or other device
for angle measurements.
CHECKING AND ADJUSTING THE PERPENDICULAR POSITION OF THE CUTTING DISC AND
WORKING TABLE
Loosen the head locking lever (14).
Set the head in the position of 0º (perpendicular to the working table) and tighten the head locking
lever (14).
Loosen the working table locking knob (23), and press and hold the automatic setting lever (22).
Set the working table in the position of 0º, release the automatic setting lever and tighten the working
table lock knob (23).
Press the cutting disc guard lever (5) and lower the saw head to the extreme lower position.
Use the tool to check perpendicularity of the cutting disc in relation to the working table.
When making measurements make sure that measurement instrument does not touch any cutting
disc tooth, otherwise the measurement may be inaccurate due to the thickness of the sintered
carbide insert.
22