GRAPHITE 59G806 Instrucciones De Uso página 18

TRANSLATION OF THE ORIGINAL INSTRUCTION
NOTE: BEFORE THE TOOL IS USED FOR THE FIRST TIME, READ THIS INSTRUCTION MANUAL AND KEEP IT FOR
FUTURE REFERENCE.
PRECAUTIONS:
Do not use damaged or deformed cutting discs.
Replace the table insert, when it is worn
Use only cutting discs that are recommended by the manufacturer and comply with the standard EN 847-1.
Do not use cutting discs made of high speed steel.
Use personal protection equipment, such as:
- earmuff protectors to reduce risk of hearing damage,
- eye protection,
- respiratory system protection to reduce risk of harmful dusts inhalation,
- gloves for the maintenance of cutting disc (whenever possible, cutting discs should be held by
holder) and other rough materials.
Connect the dust extraction system when cutting wood.
SAFE OPERATION:
Each time before the saw is connected, check the power cord for damages. Have it replaced in an
authorised workshop, if any damage is found.
Before the saw is connected to the power source, always make sure the supply voltage is compatible
with the value specified on the nameplate of the tool.
Do not allow any unauthorised people, children in particular, to touch the device or its power cord, and
do not allow them in your workplace.
The cutting disc should be selected specifically for a workpiece to be cut.
Do not use the saw to cut materials other than recommended by the manufacturer.
Do not use the saw without its guard or when it is locked.
Make sure the arm is secured during mitre-cutting.
The floor around the saw should be kept clean and free of any loose materials, such as chips and other
waste materials.
Proper general and local lighting should be provided.
The mitre saw operator should be properly trained in the scope of use, operation and maintenance of
the device.
Only sharp cutting discs should be used. Pay attention to the maximum speed indicated on a cutting
disc.
Make sure the applied spacers and spindle rings are properly used according to recommendation of
their manufacturers.
If the mitre saw is equipped with a laser, it is impermissible to replace the laser with a different type.
Repairs should be performed by the laser manufacturer or by an authorised representative.
Before you begin to work, make sure the mitre saw is properly secured to the table.
SAFETY RULES FOR LASER DEVICE
The laser device used in the design of the power tool is class 2, with the maximum output of <1mW, at
radiation wavelength of 650 nm. This device is not dangerous to the eyes, however do not look directly at
the radiation source (temporary blindness hazard).
WARNING: Do not use directly at the laser beam. It is hazardous. Always observe the following safety
rules.
The laser device should be used according to recommendations of the manufacturer.
Never deliberately or unintentionally point the laser beam at people, animals or any other object than
the workpiece.
MITRE SAW
59G806
DETAILED SAFETY REGULATIONS
18