Publicidad
Idiomas disponibles
Idiomas disponibles
Manual Freewheel Levers - Jazzy ZTS
For your convenience, your travel scooter has a manual freewheel lever on each motor. Manual freewheel levers
enable you to disable the drive system in order to maneuver the Travel Scooter manually. See fi gure 9.
WARNING! Do not use the Travel Scooter while the drive motors are disengaged! Do
not disengage the drive motors when the travel scooter is on an incline or decline, as
the unit could roll on its own! Only engage the freewheel mode when on a level surface.
WARNING! It is important to remember that when your Travel Scooter is in freewheel
mode, the braking system is disengaged.
NOTE: It is strongly recommended that you do not charge your batteries while in freewheel mode.
NOTE: You must turn off the power before disabling the drive systems; otherwise, you may get an error code
on the scooter. To clear this code, turn off the scooter and place the travel scooter in drive mode. Then turn on
the scooter. The error message should be cleared. If not, contact an authorized Provider.
Freewheel Mode (Drive Disengaged)
Drive Mode (Drive Engaged)
Figure 9. Rear Components - Jazzy ZTS
To engage or disengage the drive system:
1. Locate the levers on the rear section of the scooter. See fi gure 9.
2. Pull the two levers toward the rear of the travel scooter to engage the drive motors (drive mode).
3. Push the two levers toward the front of the travel scooter to disengage the drive motors (freewheel mode).
If a lever is diffi cult to move in either direction, rock your travel scooter back and forth slightly. The lever should
then move to the desired position.
WARNING! Do not use the freewheel lever handles as tie-down points to secure this product.
12
I I . Y O U R T R A V E L S C O O T E R
IDENTIFICATION KEY
1. Manual Freewheel Levers
2. Anti-tip Wheels
Travel Scooter Series
Publicidad
