Publicidad
Idiomas disponibles
Idiomas disponibles
V. C O M F O R T A D J U S T M E N T S
POSITIONING BELT (OPTIONAL)
Your scooter seat may be equipped with an auto-type positioning
belt that can be adjusted for operator comfort. See fi gure 30. The
positioning belt is designed to help support the operator so that he or
she does not slide down or forward in the seat. The positioning belt is
not designed for use as a restraining device.
WARNING! The positioning belt should be secured
at all times. Never allow the positioning belt to hang
or drag on the fl oor as it may become entangled.
To install the positioning belt (if required):
1. Remove the seat from your scooter.
2. Place the seat upside down so that you can see the bottom of
the seat base. See fi gure 29.
3. Use a wrench to remove the two rear bolts on the outermost
part of the seat frame.
4. Insert the bolt through the appropriate ends of the positioning
belt and then reinstall the bolts back into the seat frame.
5. Tighten the bolts.
To adjust the positioning belt for operator comfort:
1. Insert the metal tab on the right side of the belt into the plastic
housing on the opposite strap until you hear a "click." See fi gure 30.
2. Pull the strap on the right side of the belt until it is secure, but
not so tight as to cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic housing.
MANDATORY! Make sure the positioning belt is
properly secured to the scooter and is adjusted
for operator comfort before each use.
MANDATORY! Inspect the positioning belt for loose
parts or damage, including tears, worn spots,
bent hardware, or damaged latch mechanisms,
dirt or debris, before each use of the scooter. If
you discover a problem, contact your authorized
Provider for maintenance and repair.
30
Figure 29. Positioning Belt Bolts
Figure 30. Positioning Belt
Travel Scooter Series
Publicidad
