Domo DO1084S Manual De Instrucciones página 28

3. If necessary, wipe the dust reservoir clean with a soft, damp cloth.
4. Once the dust is removed, close the bottom until you hear it click.
To prevent losing suction after emptying the dust reservoir, it is essential that the long interior filter is
checked for blockages.
1. To do this, completely remove the dust reservoir by unscrewing the handle counter-clockwise. Keep
an eye on the slots of the dust reservoir.
2. Then open the bottom of the filter system. The round filter is now visible.
3. Take it out of the appliance so that the cyclones are visible. Clean the plastic filter, both the top and
the bottom of the plastic filter, so that all of the holes are dust-free. If you do this with water, make
sure that the plastic filter is completely dry before using it again.
THE FILTERS
The appliance has 3 filters. In a normal cleaning session, it is sufficient to tap out the filters. It is
recommended that you thoroughly clean the filters under tepid running water 3 to 4 times per year.
Make sure that it is completely dry before putting it back in the appliance. You can also replace them if
necessary. Avoid direct sunlight or intense overheating. Never put the filters in the washing appliance to
prevent deformation. Do not use abrasive or cleaning products and wash from the bottom of the filter.
1. The round filter is located above the dust reservoir.
2. When you take the dust reservoir out of the appliance, you will see the filter at the air intake of the
appliance. Always make sure that it is free of dust and dirt.
3. There is a grille for the HEPA filter in the wheel of the vacuum cleaner. You can easily remove it
by turning the grille counter-clockwise and then removing it from the appliance. The HEPA filter
is removed from the appliance in the same way. Clean or replace the filter. Then return it to the
appliance by first putting the HEPA filter and then the grille into position and turning them clockwise
to lock them into position.
28
DO1084S
2 3
1
3
2
3 3