Publicidad
Idiomas disponibles
Idiomas disponibles
For continuous measurements,
press function mode button 4 until
the
indicator
measurement
display. To start the continuous
measurement,
measuring button 2.
The minimum measurement is
used to determine the shortest
distance from a fixed reference
point. It is used, as an example, for
determining
horizontal partitions.
The maximum measurement is
used to determine the greatest
distance from a fixed reference
point. It is used, as an example, for
determining diagonals.
("min") measuring value are
displayed in the measured value
lines a.
It is always overwritten,when the
current length measurement value
is less than the present minimal or
larger than the present maximal
value.
The
previous
maximal values are deleted by
pressing the button for clearing the
internal memory 8.
Pressing the measuring button 2
ends
the
measurement. The last measured
value is displayed in the result line
for
continuous
appears on the
press
plumb
lines
The
current
measuring value is
displayed in the
result line c. The
maximal ("max")
and the minimal
minimal
continuous
c.
Pressing the measuring button 2
again
measuring run.
Continuous
the
automatically switches off after 5
min. The last measured value
remains indicated in the result line
c.
Indirect Distance Measurement
or
The
measurement is used to measure
distances
measured directly because an
obstacle would obstruct the laser
beam or no target surface is
available as a reflector. This
measuring procedure can only be
used in vertical direction. Any
deviation in horizontal direction
leads to measuring errors.
The laser beam remains switched
on
between
measurements.
For indirect length measurements,
three
available. Each measuring mode
can be used for determining
different distances.
a) Indirect height measurement
and
Press the function-mode button 4
until the indication for indirect
height measurement
on the display.
Pay attention that the measuring
tool is positioned at the same
height as the bottom measuring
point. Now, tilt the measuring tool
-24-
restarts
a
measurement
indirect
that
cannot
the
measuring
modes
(see figure C)
continuous
distance
be
individual
are
appears
Publicidad
