MSW -SG-01 Manual De Instrucciones página 15

e) Keep the product out of the reach of children.
f) Repairs and maintenance should be carried out by qualified personnel using
only original spare parts. This will ensure the safety of use.
g) To ensure the designed operational integrity of the device, do not remove
factory-installed covers or loosen screws.
h) When transporting or moving the device from storage to the place of use,
observe the health and safety rules for manual handling applicable in the
country where the device is used.
i) Avoid situations where the unit stops mid-operation under heavy load. This
can cause overheating of the drive elements and consequent damage to the
equipment.
j) Do not touch any moving parts or accessories unless the device is unplugged.
k) Do not carry or hang the unit by the pressure hose.
l) Maintenance and replacement of hoses, nozzles, etc. should be performed
only with the compressed air supply disconnected and the tank depressurized.
m) Use air to power the unit, no other gases are allowed.
n) Transport the unit in an upright position.
o) Only sandblasting material designed for sandblasting machines may be used in
the device. It is forbidden to use ordinary sand!
p) Whenever the unit is transported or not in use, the pressure in the sand tank
should be relieved. The pressure gauge should read 0.
q) Do not exceed the recommended supply pressure as this may damage the unit.
r) Do not exceed the maximum permissible operating pressure of the unit!
CAUTION! Although the product has been designed to be safe and
has adequate safeguards and despite the additional safety features
provided to the user, there is still a slight risk of accident or injury
when handling the product. Caution and common sense are advised
when using the product.
3. Instructions for use
The product is intended for spraying liquid material collected in the attached
container, e.g. chemicals, preservatives, etc.
The user is responsible for any damage resulting from misuse.
3.1.
Product overview