Publicidad
Idiomas disponibles
Idiomas disponibles
3.2.
Preparation and use
POSITIONING OF THE UNIT
The ambient temperature must not exceed 45°C and ambient humidity should not
exceed 85%. Use the unit in properly ventilated spaces. Do not block the air outlet
of the unit. Keep the unit away from any hot surfaces. Always use the device out of
the reach of children, animals and people with limited mental, sensory and
intellectual functions. The work area should provide immediate access to the
compressed air shut-off valve. Make sure that the pressure of the air supply to the
unit does not exceed the recommended range. The air supplied to the device should
be cleaned and dried. The minimum diameter of the air supply hose is 10 mm.
ASSEMBLY AND USE
•
Attach the device to the pneumatic hose connected to the pneumatic
system (during installation, the air supply should be turned off) through the
pneumatic tip (G) at the bottom of the handle (D).
IMPORTANT: if the air supply hose is longer than 8 m, the supply pressure
must be increased.
•
Attach the adapter for the pneumatic quick coupler to the tip and select
the appropriate hose with a tip. Check the installation for tightness by
unscrewing the compressed air supply and pressing the trigger several
times. Then, after releasing the trigger, listen to whether the air is escaping
somewhere.
•
If the installation is tight, you can unscrew the container (H) from the body
(C) and fill it with spraying material. After filling, screw it tightly to the gun
body.
•
Make a short test spraying, e.g. on a piece of cardboard, to check and, if
necessary, adjust the spray using the knob (E) on the handle (D).
You can start working with the device, but avoid positioning the gun with
•
the container upside down.
3.3.
Cleaning and maintenance
a)
Always clean the product after using it. After unscrewing the container, blow
out the rest of the material collected in the gun by pressing the gun trigger.
Likewise, rinse and blow out the used probe. Rinse the container thoroughly
to remove material residue.
b)
Never leave any unused spraying material in the gun or in the container.
c)
After each cleaning, all parts must be thoroughly dried (or blown out with
compressed air) before the device is reused.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
Publicidad
