Publicidad
Idiomas disponibles
Idiomas disponibles
2. When the ambient temperature is below -20°C or above 55°C, please do not use the transfer
chair. Do not use the transfer chair.
3. The original charger is a 29.4V/1.2A charger, which complies with part 1 of the EN60601-1
Medical Electrical Equipment: General Safety Requirements.
WARNING
4. When the ambient temperature is below 0°C, please do not charge it to avoid damage to the
battery to avoid damage to the battery and injury.
5. Do not place the equipment in such a way as to make it difficult to use the power
TRANSFER
1.
Move the transfer chair close to where the patient is sitting or lying in bed.
2.
Unlock the buckle and latch on the back of the backrest to separate it.
3.
By pressing the up/down button, adjust the seat to the appropriate height (2-3 cm higher than the chair, sofa or bed
the patient is sitting on).
4.
Push the transfer chair inwards, lock the front wheel brake switch so that the lift cannot move. Let the patient step on
the chair's foot pedal.
5.
Help the patient to sit in the chair by closing the left and right backrests.
6.
When the patient is seated properly and the left and right backrests are closed, lock the safety buckle and the latch. The
chair can now be moved.
TROUBLESHOOTING
This product has an abnormal warning function. When a failure occurs, the three LED indicators on the control panel flash at the
same time. Please check according to the warning signal table. If the problem persists after the check, please contact your
service agent.
Anomaly analysis table
Anomaly
All three indicators are flashing
SAFETY PROTECTION AND ACCIDENT HANDLING
Loading: See Chapter "User's guide -- Loading operation".
If the transfer chair fails during lifting, if it cannot be stopped when the button is released or a button is pressed, please remove
the battery immediately to stop the lift forcefully.
MAINTENANCE AND DISINFECTION
This transfer chair requires regular care and maintenance. The user can carry out a routine check and maintenance, other services
should be carried out by the dealer. Proper maintenance can keep the transfer chair in good working order. If you encounter any
problems during maintenance, please contact your dealer or the service department.
DMI-F-07_Annexe 2_Notice.2
Chargers are not permitted.
to electrically isolate the equipment circuits from the mains supply. power supply
Analysis
External force or contact with other
objects during the reset process,
causing anomalies.
Troubleshooting
Remove obstacles and perform the
reset operation again. In standby mode
(all three lights are off), press the (up)
and (down) buttons simultaneously for
3 seconds to initiate the reset function.
23
Publicidad
