Publicidad
Idiomas disponibles
Idiomas disponibles
SF 1046
MOUNTING
1. Assembly of the fan body
STEP 1: Remove the fan blade locknut from the motor assembly by turning it clockwise. Remove the
rear grill locknut by turning it counterclockwise and pulling it away from the main fan unit.
STEP 2 - Place the rear grill onto the shaft of the motor assembly, making sure it lines up with the top
and bottom plastic pin, then add the rear grill lock nut, turning it clockwise to secure it in position.
STEP 3: Position and push the fan blade onto the motor assembly shaft, then fit the locking screw and
turn counterclockwise until the fan blade locks into position.
STEP 4: Attach the front grill to the rear grill using the retaining ring. To do this, place the ring on one
of the racks, matching the inner hole of the ring with the edge of the rack and then join the two racks
in the same way. In the QR you can see an example of how to mount the grill.
2. Assembly of the base
STEP 1: Insert the Adjustable Base Post through the hole in the base.
STEP 2: While holding the base post in place, flip it over and place the washer on the bottom of the
adjustable base post.
STEP 3: Secure the base and washer in position by inserting the base locking screw and turning it
clockwise.
STEP 4: Insert the lower trim through the post, for this you must momentarily remove the thread that
fixes the height of the fan.
3. Fixing the fan body to the base
STEP 1: Loosen the height adjustment knob by turning it counterclockwise, then remove the inner post
from the adjustable base.
STEP 2: When the post is at the desired height, tighten the knob by turning it clockwise to secure the
post in position.
STEP 3: Loosen the locking screw on the fan body by turning it counterclockwise, then place the body
on the base post.
STEP 4: Carefully turn the locking screw clockwise to lock the fan body in position.
Note: If the base post cannot be fully inserted, loosen the main unit lock screw further.
Be careful not to overtighten the height adjustment knob and lock screw on the main unit, as this may
damage the fan.
Instructions for use
Before connecting to electrical power, place the fan on a flat, stable surface, leaving enough distance
between the fan and any objects that could be damaged or caught in the fan's rotating blades.
1. Plug in and turn on the fan.
2. Press button 1, 2 or 3 to select the fan speed. If you do not want to activate the timer, make
sure the rotary button is in the "ON" position.
3. Push/pull the engine rocker rod. The fan will start/stop oscillation.
4. Timer function. Adjust the time with the rotary knob turning clockwise.
5. Press the 0 button to turn off the fan
11
Publicidad
