Pedestrian Open/Close Programming; Selection Of The Modes And Control Board Functions (Sw2) - Erreka AM600S Manual Del Instalador

PROGRAMMING AND STARTUP
4

PEDESTRIAN OPEN/CLOSE PROGRAMMING

Start programming mode
Programme the slowdown start points
Finish the programming mode

The pedestrian opening and closing of the gate
will be memorised.

The positions in which the gate begins to slow
down, both on opening and in closing, will also
be memorised.
5

SELECTION OF THE MODES AND CONTROL BOARD FUNCTIONS (SW2)


Using SW2, choose the required options (see "SW2 Functions during use (DIP1=OFF)" on page 25).
28
Installation Guide
1 Close the gate by pressing PUL1.
2 Ensure that DIP7 is "OFF" if the operator does not
have an encoder, or "ON" if an encoder is fitted.

If the encoder is not enabled (DIP7=OFF),
operation times will be memorised.
3 Place DIP8 in "ON" (slowdown).
4 Place DIP1 and DIP3 in "ON"; DIP2, DIP4, DIP5 and
DIP6 in "OFF".

DL3 lights up,
programming mode.
1 Start to open the gate: press ST2; the gate begins
to open.
2 Start slowdown in opening: press ST2 (or A.P. or
the transmitter) at the point chosen for the start of
slowdown (DA1).
3 Finish the pedestrian opening: press ST2 at the
required position for the end of pedestrian opening
(DC1).
4 Start closing the gate: press ST2; the gate begins
to close.
5 Start slowdown in closing: press ST2 (or A.P. or
the transmitter) at the point chosen for the start of
slowdown (DC1).
6 Wait for the gate to come to a halt due to the
action of the closing limit switch.
1 Place DIP1 and DIP3 in "OFF".

DL3 will remain off.
indicating that it is in