HOW TO USE
This appliance is intended for household use only.
GETTING STARTED
• Remove all packing material, any stickers, and the plastic band around the
power plug.
• Remove and save literature.
• Please go to www.prodprotect.com/blackanddecker to register your
warranty.
• Before first use, clean appliance and plates according to instructions in
the CARE AND CLEANING section of this manual.
ATTACHING THE PLATES
Important: Never power on this appliance
without both cooking plates securely attached.
Caution: Attach plates when the appliance is cool.
1.
To attach the top plate, insert the longer tabs
into the slots closest to the hinge. Press
down gently until the plate snaps into place.
2.
Securely attach bottom plate using the
technique as described in Step 1.
PREPARATION
Note: Aerosol cooking spray should not be used
on the plates.
1.
Set the appliance on a stable, level, heatproof surface.
2.
Close lid and plug cord into outlet.
3.
The red power light will come on as long as the appliance is connected
to the electricity supply.
4.
The green ready light will come on when the elements reach the
correct cooking temperature, then cycle on and off with the
thermostat.
5.
Wait till the green light comes on before starting to cook.
MAKING TOASTIES (sandwich plates)
CAUTION: Don't use raw meat of any kind in the appliance. All fillings must
be safe and ready-to-eat before cooking.
1.
Cut 4 slices of bread to overlap the plates by about 1/4 inch (0.5cm) on
all sides. Fresh sliced bread is best.
2.
Spread butter/margarine thinly on each slice. Don't use low fat spread.
Low fat spreads may burn, damaging the non-stick surfaces.
Toasties are made buttered side out. Put 2 slices of bread, buttered
3.
side down, on the bottom toasting plate.
4.
Press the bread gently into the hollows in the toasting plate with a
wooden spoon.
5.
Fill the hollows formed in the bread with two level teaspoons of filling
per toastie. More than that amount may cause the filling to ooze out.
5