Specifications; Maintenance Tips - General MMD950 Manual Del Usuario

REL measurements.
If either calibration check produces a non-zero reading for 10 seconds, and the
meter is still under warranty, call General's Customer Service Department at
212-431-6100 to arrange to return the meter for service or replacement.

SPECIFICATIONS

Measurement Ranges
Measurement Accuracy
Length of Test Pins
Length of Remote Probe Cable
Measurement Depth (pinless mode) 4 in. (102mm)
LCD Range/Size
LCD Resolution
Bar Graph Composition
Bar Graph Resolution
Auto Power Off
Low Battery Warning Level
Current Consumption
Operating Temperature
Dimensions
Weight
Power Source

MAINTENANCE TIPS

When the
the 9V battery (although measurements will remain valid for hours afterwards.)
When the tips of the remote probe's 10mm test pins show signs of wear,
replace them with a pair of 10mm or 15mm pins included in the case.
Remove the battery when storing the meter for an extended period of time.
Never drop or disassemble the meter or immerse it in water.
10
icon appears at the upper left of the LCD, it's time to replace
6.0 to 87.6% WME and 0.1 to 99.9 REL
±3% in pin mode
10mm (0.4 in.) on remote probe; 10mm and 15mm
(spares)
46 in. (1.168m)
6.0 to 87.6 count with 0.9 in. (23mm) high digits
0.1%
40 LEDs of 3 colors: green (0 to17%), yellow
(17 to 30%) and red (>30%)
±1 LED (±2.5%)
After 3, 5 or 10 minutes (user selectable) with
0% reading
<6.5VDC
<70mADC
32° to 122°F (0° to 50°C) @<80% relative humidity
9 x 2.75 x 1.625 in. (229 x 70 x 41mm)
8 oz. (249g)
9V battery (included)