BGS technic 8315 Manual De Instrucciones página 3

GENERAL
The professional Brake Bleeding is suitable for daily
use in workshops and for bleeding brake and clutch
systems. Brake fluid and air pressure is separated by
a rubber membrane and water comes not into the
brake fluid.
SAFETY CAUTION
The Air Brake Bleeder is under pressure. It is therefore very important that there is no pressure in
the system when you want to fill it.
COMPONENTS
1 Air nipple
2 Pressure regulator
3 Air inlet valve
4 Safety valve
5 Shut-off valve
6 Sealing cap
7 Filling hose
8 Pressure gauge
9 Filling valve
10 Quick coupling
11 Venting adapter
12 Bleeding adapter
13 Bledding bottle
14 Syring
PREPARATION
Install the red pressure hose for the brake fluid as follows:
Remove the protection hose from
the hose connector
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Professional Brake Bleeder
1
Insert the hose connector into
the connection on the device
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
2
Tighten the fixing screw by
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 8315
3
hand