EINHELL ST 350 Manual De Instrucciones página 9

Anleitung ST 350 14.11.2001 9:29 Uhr
1
Fitting the inspection guard
Inspection guard
Important! Wear goggles!
2
Changing the saw
Releasing the saw blade:
Turn screws anticlockwise.
Insert the saw blade in the ram up to the stop and
tighten the two screws of the retention clip.
Important: Make sure that the saw blade sits properly
in the slot of the roller and ram.
5
Seite 9
3
On/Off switch
Switching on:
Continuous operation: Lock the On/Off switch with the
Switching off:
4
Undo the two screws to set the base to an angle of up to
45° on the right or left side.
Cutting veneered chipboard:
1. Use a fine saw blade
2. Position the base on the uncovered area
3. Advance the saw with little force
Support
Cutting holes: Possible only in chipboard and wood unless you
drill a hole first. Press the jigsaw firmly against the support and
move slowly in cutting direction.
GB
Locking button
Press the On/Off switch
locking button
Press the On/Off switch and
release
9