Publicidad
Idiomas disponibles
Idiomas disponibles
The max. tightening torque for the G3/8" connections must not
exceed 10 Nm!
Before use make sure that gaskets are placed correctly and all parts are
fitted and connections are dry.
All water lines should be mounted as follows to ensure correct
functionality:
Bends immediately behind the crimped connection of the hose have
a major impact on life cycle. It is recommended to bend the hose no
more than 30 mm behind the pressing sleeve. The specified minimum
permissible bending radius R refers to hose parts after 30 mm.
The minimum bending radius should be R45 mm.
Min. 30 mm
Also make sure that the hose does not twist on itself during assembly.
Torsional loading can also reduce the life cycle.
Make sure that the hose is not subject to unnecessary strain during
assembly. For example avoid stretching the hose if it is too short.
Avoid severe and/or unnecessary bends in the hose, as these can cause
kinking and shorten the life cycle of the hose.
7
Publicidad
