Duronic AF34 Guía Rápida De Inicio página 16

(Zone 1 and Zone 2 Working at the Same Time / Dual Zone Cooking )
Sync Cook mode uses both cooking Zones to either cook both drawers of food on
the same temperature and time, or allows you to use the larger AFD1 drawer to
cook food in.
1. Press the Power Button.
2. Press the Sync Cook button.
3. Press the Zone 1 button.
4. Select a pre-set cooking mode (ie fish, meat etc) -even if you do not want
to use it, you will need to select one of them in order to then set your own
custom time/temperature.
5. Adjust the temperature and time using Temperature +/- buttons and Time +/-
buttons according to what you require.
6. Press the Start/Pause button.
7. Both cooking zones will begin to heat up and start cooking the food inside.
When the cooking time comes to an end, it will make a beeping noise, both
Zones will stop cooking and the unit will switch itself off.
Using the Lamps
To check on the progress of your food at any time, press the button for Lamp 1 or
Lamp 2. The light will stay on for a few seconds before switching off again.
Adjusting the Temperature
The temperature range is 50-200°c. Each time you press the +/- buttons the
temperature will increase or decrease in 10°c increments. If you are on 200°c and
press the + button it will loop back around and adjust to 50°c. Whilst setting the
temperature, the digits will flash on and off. Once you have set the temperature
you like and have stopped pressing the +/- buttons, the digits will flash 3 times
and then stay on continuously – this means the temperature has been set
successfully.
How to Use (Continued)
Sync Cook
16