Publicidad
Idiomas disponibles
Idiomas disponibles
Reset instructions
This heater is equipped with an automatic Safety Shutoff Switch
for overheat protection, which is activated as the internal
temperature exceeds normal operating temperatures.
IF THE HEATER SHUTS DOWN
1) TURN IT OFF
2) UNPLUG IT AND WAIT 10 MINUTES
3) PLUG IN AND TURN ON
Fan operation
To use the unit as a cooling air circulator without heat, turn the
power switch knob to
setting.
If your Heater fails to operate
• Be sure it is plugged in and that the electrical outlet is working.
• Check for any obstruction. If you find an obstruction, turn the
heater OFF. Unplug the heater and wait at least ten minutes for
cool-down. Carefully remove the obstruction. Re-plug the
heater in and restart it as described in OPERATION section.
• If you still notice the same defect, detach the plug from the
outlet and have the appliance checked by service personnel
only.
• Check that the set temperature is not lower than the current
room temperature. Set the desired temperature higher than
the current temperature to restart the heater.
and the thermostat to its highest
Operation
15
Publicidad
