Replacing The Hip™ Cleaning Solution - SciCan HYDRIM M2 G4 Manual Del Operador

7. Care and Maintenance
7.2 Replacing the HIP™ cleaning solution
Only replace the cleaning solution with HIP™ cleaning solution, which is used in dilute form
as a detergent for the cleaning of surgical instruments in the HYDRIM washer.
It is a colourless and almost odourless liquid that is completely soluble in water.
Nonetheless, some precautions must be taken to safely handle this chemical.
For more information, see section 7.1, the HIP™ cleaning solution.
NOTE: To avoid spillage, replace the solution container only when the message appears
and be sure to wear gloves.
When a red X appears on the water softener/detergent icon. Press on the icon to determine
if the problem is with the water softener or cleaning solution level. If the cleaning solution
must be replaced, a red X will appear next to it.
To replace the cleaning solution, follow these steps:
7.2.1 Replacing the HIP™ Cleaning Solution
The HYDRIM M2 G4 uses a 3.8L / 1 US gallon container of HIP™ Cleaning Solution (Part
number CS-HIPL). Only use the recommended cleaning solution because the HYDRIM was
tested and validated using solely HIP™. Also, rea d the MSDS before handling HIP™ for the
first time.
To order additional HIP™ Cleaning Solution, contact your local dealer. When the message
"no detergent" appears on the screen, the cleaning solution container is empty and is in
need of changing. To avoid spillage, replace the solution container only when the message
appears and be sure to wear gloves.
1.
Open the cleaning solution door (see picture 1 below).
2.
Pull out the empty solution container and rotate backwards into the upright position (with
the connector at the top).
3.
Disconnect the cleaning solution connector by unscrewing anti-clockwise (see
picture 2 on next page).
4.
Remove and dispose of/recycle the empty container as appropriate and in accordance
with local guidelines.
33