BTI profiline -BS 6-25 TE Instrucciones De Servicio página 21

Declaration of Conformity
We declare under our sole responsibility that the prod-
uct described under "Technical Data" is in conformity
with the following standards or standardization docu-
ments: EN 60745 according to the provisions of the
directives 89/336/EEC, 98/37/EC (until Dec. 28,
2009), 2006/42/EG (from Dec. 29, 2009 on).
Technical Data
Screwdriver
Art. No.
Rated power input
Output power
No-load speed
Rated speed
Tool holder
Max. screw dia.
Weight according to EPTA-Procedure 01/2003
Protection class
Assembly
Changing the Tool (see figure A)
Pull off the screwing-depth stop 4 toward the front. Pull
out the screwdriver bit 1. If required, the universal bit
holder 9 can also be pulled off and replaced.
After changing the tool, reattach the screwing-depth
stop 4.
Operation
Starting Operation
Observe correct mains voltage! The voltage of
the power source must agree with the voltage
specified on the nameplate of the machine.
Power tools marked with 230 V can also be
operated with 220 V.
Reversing the Rotational Direction
The rotational direction switch 8 is used to reverse the
rotational direction of the machine. However, this is not
possible with the On/Off switch 7 actuated.
Right rotation: For driving in screws, push the rota-
tional direction switch 8 left to the stop.
2 609 932 572 • 22.6.07
Jürgen Dietz
General Manager
BTI Befestigungstechnik GmbH & Co. KG
74653 Ingelfingen
BTI-BS 6-25 TE
W
W
rpm
rpm
¼" hexagon socket
mm
kg
Left rotation: Push the rotational direction switch 8
right to the stop (for unscrewing screws).
Switching On and Off
To start the machine, press the On/Off switch 7 and
keep it depressed.
To lock the pressed On/Off switch 7, press the lock-
on button 6.
To switch off the machine, release the On/Off switch
7 or when it is locked with the lock-on button 6, briefly
press the On/Off switch 7 and then release it.
Adjusting the Speed
The speed of the switched on power tool can be varia-
bly adjusted, depending on how far the On/Off switch
7 is pressed.
Light pressure on the On/Off switch 7 results in a low
rotational speed. Further pressure on the switch results
in an increase in speed.
Adjusting the Screw-in Depth (see figure B)
With the adjustment sleeve 3, the screw-in depth of the
screw head into the workpiece can be preset in 8 lock-
ing steps per full turn. Each step corresponds with a
0.25 mm change of the screw-in depth.
Turning the adjustment sleeve 3 in clockwise direction
results in a greater screw-in depth; turning in anticlock-
wise direction reduces the screw-in depth.
The required setting is best determined by testing.
English–3
i. V. Günter Hub
Purchasing Manager
BTI-BS 6-45 TE
9013293
701
327
0–2500
0–1700
¼" hexagon socket
6
1.5
/II
9013302
701
327
0–4500
0–3000
6
1.4
/II