AENO RC4S Guia De Inicio Rapido página 11

and/or replacement parts. Do not leave the device switched on without supervision
Do not plug the device into the power supply with wet hands. Do not put anything
on the vacuum cleaner. Keep pets away from this device when it is in operation. Do
not place the device in such places where it can easily fall off. If the body of the vacuum
cleaner becomes too hot while charging, stop the charging process and contact the
service center. The water tank can only be filled with purified water. Do not add
fragrances, detergents, alcohols, or hot water to the water tank. Do not wet-clean on
carpeting. The vacuum cleaner must be turned on and charged to run on a schedule.
Do not use the device if it has been in water or if its charging base, battery, power cord
and/or plug is damaged. Never attempt to disassemble and/or repair the device by
yourself. The device should be repaired by a qualified technician. Do not allow children
to use and/or play with the vacuum cleaner without supervision. Detailed information
can be found in the Installation and Operation manual available for download at
aeno.com/documents.
Preparing the device for operation (Fig. B, C)
1. Remove the plugs on the sides of the vacuum cleaner.
2. Attach the side brush.
3. Place the charging base on a flat, stable, horizontal surface.
WARNING! Make sure that the self-cleaning station has a dust bag installed
and that the station cover is tightly closed.
4. Connect the charging base to the mains by inserting the plug of the power
cord into the base and the plug of the power cord into the power outlet.
5. Make sure that the container is inserted into the body of the vacuum cleaner and
proceed to charge. Connect the pins on the container to the pins on the base for
charging, as shown in Figure C. If the vacuum cleaner is positioned correctly, the LED
on the base will start flashing. When charging is complete, the LED will light steadily.
Control the vacuum cleaner with the buttons on the body
WARNING! Remove any hazardous objects, power cords, or items of value from
the floor before using the vacuum cleaner.
Press and hold the "Start/Stop" button
The vacuum cleaner will go into standby mode. Select the type of cleaning:
11
for 3 seconds to turn the power on.
aeno.com/documents