AENO RC4S Guia De Inicio Rapido página 13

• Connect your smartphone to the Wi-Fi hotspot named "SmartLife-XXXX". Go
back to the app. Click the "Connect" button.
• Wait for the connection process to complete and click "Done".
NOTE. If the connection to the app fails, make sure the device is connected to
a power source, turned on and charged, check the Wi-Fi router settings at
https://aeno.com/router-help and reconnect.
Replacing the dust bag (fig. E)
WARNING! Disconnect the base in advance to charge it from the mains.
1. Open the cover of the self-cleaning station.
2. Remove the bag by pulling the cardboard closure.
3. Install the new bag as shown in the illustration. Make sure that the suction
port on the gate is open. Close the station lid tightly.
The states of the LED indicator of the charging base
Indicator
White
Red
The vacuum cleaner care (Fig. F)
1. Remove the container from the body of the vacuum cleaner.
2. Pour the remaining liquid out of the water tank.
3. Empty the contents of the dust tank into the trash.
4. Clean the HEPA filter and pre-filter with a dry brush or cloth.
WARNING! Do not wash the dust tank and HEPA filter with water.
13
Status
Lights up
Flashing
Flashing (3 times)
Lights up
Flashing
Does not burn
Description
Charging is over, the base is in the
standby mode
Charging in progress; robot dumps trash
into the self-cleaning station
The base is connected to the mains
The dust bag missing or improperly
installed; station cover is not closed or it
is closed poorly
Device failure
The device is switched off and
disconnected from the mains
aeno.com/documents