Publicidad
Idiomas disponibles
Idiomas disponibles
GB
- If using the nylon brush
(10/18), place the guiding roller
(11) into the transport position
(20).
- If using the metalbrush (17),
place the guiding roller (11) into
the working position (18).
2. Release the guiding roller (11) by
pushing the retaining tab (19) and
remove the guiding roller (11).
Mounting the additional handle
1. Unscrew the additional handle
4
(13) to take apart.
2. Insert the additional handle (13)
into the holder beneath the han-
dle (1).
3. Screw the additional handle (13)
tightly using the grip screw (6).
There are several possible
latching positions.
Operation
Caution, risk of Injury!
Always check whether the de-
vice functions correctly before
using it.
Always wear eye protection
when operating the device.
Always unplug the device before
working on it. There is a risk of
injury.
Observe the noise protection and
other local regulations. .
Switching ON and OFF
1. Loop the end of the extension cable
and hang it onto the cable tension
relief (5) to ease the tension on the
cable. See detailed illustration
24
2. Plug the tool into the mains.
3. To turn on, use your thumb to actuate
the switch lock (4), then press the On/
Off switch (2). Release the switch lock.
4. To turn off, release the On/Off switch (2).
There is no continuous operation mode.
The brush will keep rotating for a
few seconds after the device has
been switched off. Keep the brush
away from hands and feet.
Do not try to lock the on/off
switch in place. Do not use the
device if the switch is damaged. A
damaged switch may cause an
injury risk due to the motor not
being switched off after releas-
ing the on/off switch.
Device adjustments
Length adjustment:
The telescopic arm enables you to adjust
the device to your individual height.
Unfasten the screw socket (7). Adjust the
telescopic arm (8) to the desired length
and re-fasten the screw socket.
Adjusting the splash guard:
You can adjust the splash guard (9) by
sliding it backwards and forwards.
Setting the rotation speed:
There are six possible rotation speed set-
tings on the speed regulator (14).
Practical tips
• Always inspect the brush before
.
Caution, risk of Injury!
starting the device. Never use
damaged brushes. Replace any
damaged or worn brush.
Publicidad
