Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT: Do not grasp console to move compactor. Begin in the room where the compactor will be located.
1. Attach Power cord to the cord clip
A
Remove compactor from shipping carton and all packaging
materials such as tape and shipping pads. Use a mild detergent
and warm water to remove waxy residue caused by shipping
material. Dry thoroughly with a soft cloth. For more information,
see "Cleaning". Be sure the power cord is attached to the cord
clip on the rear of the compactor
3. Remove the shipping base
A
A. Leveling legs
B. Shipping
base
Place the other 2 corner posts on the floor to the side of the
compactor. Grasp the sides of the compactor cabinet and put
compactor on its side on top of the corner posts. Remove the
shipping base from the bottom of the compactor.
Excessive Weight Hazard
Use two or more people to move and install appliance.
Failure to do so can result in back or other injury.
A. Cord clip
B
Unpacking
WARNING
2. Drawer placement
Place the 2 corner posts from the carton on the floor near the
compactor. Open the compactor drawer and remove any shipping
materials or other items from the drawer.
NOTE: Do not remove the compactor bag.
Grasp the handle and raise the front of drawer until it clears
the drawer stops. Grasp sides of drawer and lift drawer out of
compactor. Place the drawer on the 2 corner posts.
3
Publicidad
