Publicidad
Idiomas disponibles
Idiomas disponibles
Your new compactor is designed to give you many years of dependable service. However, there are a few things you are expected to
do in order to properly maintain your compactor. This section will tell you how to clean and care for your compactor.
Before cleaning the compactor, turn the Key-Knob (or Key-Switch) to the OFF & LOCK position and remove it.
NOTE: Any services other than those outlined in this section should be performed by a designated service representative.
Cleaning Exterior Surfaces
Wash exterior surfaces (including stainless steel) with a clean sponge or soft cloth and a mild detergent in warm water. Do not use
abrasive or harsh cleaners. Rinse and dry thoroughly with a soft cloth.
Wipe up spills right away. Some foods can damage the finish if left on the compactor surface.
Cleaning Inside the Drawer
NOTE: You may want to wear gloves since there may be bits of glass in the drawer.
1. Side-Lock latch
Remove the bag. See "Removing a Filled Bag."
Press down on the lever-action lock (or Side-Lock latch). Hold
the lever-action lock down and tilt the side of the drawer out
until the lock clears the drawer front.
COMPACTOR CARE
Cleaning
WARNING
Cut Hazard
Wear gloves when cleaning inside the drawer or cabinet,
or the ram.
Failure to do so can result in cuts.
2. Drawer side can be removed
NOTE: If desired, the drawer side can be removed by tilting it
up, then lifting it out.
Wash the interior of the drawer with a clean sponge or soft cloth
and a mild detergent in warm water. Rinse and dry thoroughly
with a soft cloth. If the drawer side was removed, slide it back
into the tilted position. Press the lever-action lock (or Side-
Lock Latch) down while pushing the drawer side to the upright
position. Latch the drawer side by pushing up the lever-action
lock (or Side-Lock Latch).
9
Publicidad
