LORCH i-Torch i-LTG Manual De Instrucciones página 24

7 .2 TIG operation
Avoid contact with hot torch parts
and work pieces.
 Please follow the instructions during the
complete TIG operation.
 Set the tig torch to the required start posi-
tion.
 Ignite the arc with the on/off button.
 After ignition keep the torch at the start
point until establish a weld pool.
 Guide the torch constant during the whole
seam length following the instructions
 Press the stop button at the end of the
seam
 Continue to hold torch at final position for
a few seconds to allow molten pool to
solidify without atmospheric disturbances
(shielded by gas flow)
The operator must wear protective
clothing, and adequate ventilation
must be available (see „5 Safety
measures and instructions" on
page 21).
- 24 -
Operation
12.15