The majority of faults is caused by the use of batteries with low charge.
Check them and replace them as shown in chapter INSERTING THE BAT-
TERIES.
● IF THE REMOTE CONTROL IS NEW AND IT DOESN'T WORK
Check that you have observed the indications of the manual; if necessary, repeat all the steps
described above.
● IF THE REMOTE CONTROL STOPS WORKING
Remove the batteries, press a couple of buttons, then insert NEW batteries. Make sure that the
remote control is pointing at the device and that there are no obstacles in the way.
● IF SOME FUNCTIONS ON THE REMOTE CONTROL ARE NOT AVAILABLE
See the chapter BUTTON AND FUNCTION DESCRIPTION to obtain the desired function.
● HOW TO CHECK IF THE REMOTE CONTROL IS TRANSMITTING INFRA-RED SIGNALS
The human eye is not capable of detecting infra-red signals; use a camera (such as the smart-
phone camera).
Focus on the infra-red LED located on the front of the remote control (not the red LED on the
top) and keep pressed the ON/OFF [
If, using the camera, you see the LED lighting with short white/blue fl ashes, then the remote
control is working and it emits infra-red signals.
WARRANTY: 2 years
Keep the purchase docket to validate the warranty.
The warranty ceases to be valid if the product is tampered with or used incorrectly.
The symbol of a bin crossed out on the appliance indicates that the product at the end of its life cycle should be
disposed of separately from other refuse. The user must therefore hand over the appliance at the end of its life
cycle to an approved recycling centre for electrical and electronic refuse, or return it to the seller each time a new
or replacement appliance is purchased. Proper separate refuse collecting for the later initiation of the appliance
sent for recycling, treatment and environmentally friendly disposal, contributes to reducing negative effects on
the environment and on our health and encourages the recycling of the material used to make it.
TROUBLESHOOTING
!
WARNING!
] button on the remote control.
7
EN
!