Domo OFDO1115BL Manual De Instrucciones página 36

Blend/clean: mix and cleaning
If your soup does not have the desired consistency, you can continue to mix the soup with this function.
Select the 'Blend' programme and confirm by pressing the start button. Press and hold the start button
until you have the desired consistency. The blender does not heat with this programme. We advise you
not to use the blend function for longer than 20 seconds at a time. This is also how you can clean the
appliance after use.
CLEANING AND MAINTENANCE
· Do not place the appliance in the dishwasher.
· Remove the lid and clean with a damp cloth.
· Be careful when cleaning the blade.
· Fill the jug with warm water and a little bit of soap. Clean your appliance with the blend/clean function
(see the section on use). Clean the inside of the jug with a soft sponge. Do not use a scouring pad as
this will scratch the base.
· After cleaning, dry all parts thoroughly.
· Do not immerse the appliance in water.
PROBLEMS AND SOLUTIONS
Problem
The lights on the display
are off
The light of the chosen
setting is on, but the
appliance doesn't work
The appliance stops
working
You can hear several beeps
and the light of the chosen
program blinks
The food is burned
The error message 'E1'
appears on the display.
36
DO1115BL
Causse
There is a problem with the
connection
There are too many ingredients
in the jug, the lid is not in place
You didn't confirm the setting
with the start button
There is not enough liquid in
the jug
There is too much liquid in the
appliance
The overfill sensor is dirty
The jug wasn't filled between
the min and max indication
lines.
There are too many ingredients
in the pitcher.
Solution
Check if the power cord is properly
connected
Remove some of the ingredients.
Ensure the lid is in place
Press the start button
The appliance has a boil dry
protection. The appliance will shut
down when there is not enough liquid
used
The appliance has sensor to make
sure it doesn't overflow. Pour some of
the liquid from the jug.
Clean the sensor with a damp cloth
Ensure the base is always covered
with liquid, between the min and max
indication.
Make sure that the contents of the
pitcher are between the minimum
and maximum levels.