LEMANIA ENERGY T13 Manual De Instrucciones página 16

Note: Surface charge detected
If the Tester detects a surface charge, the following procedure must be followed. Once complete proceed with the
test.
Turn ignition key
to ON position
Headlights –
[Low & High]
turned: ON
Note: Weak terminal connections detected
When the connection to the battery is insufficiently secure to accurately perform a test. The tester will display the
following icon on the screen. Disconnect the tester from the battery, remove potential dirt from the terminals and
reconnect it firmly. Repeat the test procedure.
Note: Low state of charge (>75%), temperature selection
If the Tester detects that the battery is discharged it will prompt the temperature selection option
(-) 0°C and below
Note: Low state of charge (>75%), charge status selection
If the Tester detects that the battery is discharged it will prompt the charge status selection option
Before charge selection
Turn ignition key
OFF position

Headlights [Low
& High]: OFF
Flashing
alternately
After charge selection
(+) 0°C and above
Page 16 of 60