LEMANIA ENERGY T13 Manual De Instrucciones página 17

Performing a Quick Test: Starter
Once the clamps are connected follow the on-screen instructions to perform a starter test.
1
Select the starter test
Interpretation of the Starter Test results:
7. Battery Voltage before cranking: 13.40 V
Indicates the state of charge (SOC) of the battery before cranking the engine.
8. Maximum voltage drop during cranking: 9.36 V
Indicates the captured voltage drop when the Starter crank the engine due to the load during starting.
9. Cranking Voltage: 10.73 V
Indicates the actual cranking voltage. If the voltage drops below 9.6V for 12V system or below 19.2V for 24V
system that means that the battery is weak and is coming to the end of its operating life.
10. Maximum Recovered Voltage: 13.38 V
Indicates the highest climb voltage before going into the charging while the engine is running.
11. Cranking period before engine ignition starts: 0.78S
Indicates the period (in seconds) during cranking before the engine starts and determines the condition of
the battery. The shorter the cranking time the better the condition of the battery. Weak batteries will take
longer to start the engine.
12. Average recovered voltage: 13.18 V
This voltage captured during recovery stage after ignition before going to charging volts. It tells how good the
battery is on its voltage recovery compared to the state of charge (SOC) voltage.

2
3
1. Battery Voltage
before cranking
3. Cranking
Voltage
5.Cranking Period
before engine
ignition starts.
2. Maximum Voltage drop
during cranking
4. Maximum Recovered Voltage
6. Average recovered Voltage
Page 17 of 60