Publicidad
Idiomas disponibles
Idiomas disponibles
Part identification
1. Inlet
2. Outlet
3. Cold water thermostat
4. Motor fan
5. Cold/heat exchanger
UPPER
FRONT
3. CAUTION
1.
This product is designed to operate lower than
400kPa supply line pressure. A pressure regulator must
be installed to reduce the water pressure lower than
400kPa.
2.
This product has cold/heat exchanger, which pressu-
re needs to be relieved by either pressure relief valve
or expansion tank/accumulator. Improper installation of
this product (such as absence of pressure relief valve or
expansion tank) may lead to serious flood and property
loss, so please make sure that this safety measures are
properly applied
3.
This product is for indoor use only and must be ins-
talled in frost-free environment. It must not be exposed
to the elements of nature. If the product is stored or ins-
talled at cold temperature below 5 Celsius(41 Fahren-
heit), the cold/heat exchanger can get damaged and
result in serious flood.
4.
Do not remove the cover of the chiller under any
circumstances without first isolating the chiller from the
6. Compressor
7. Condenser
8. Power cord
9. Drain cap
10. Drain cover
1 2
7
WARNING: This chiller is designed to
operate at incoming water pressure
from 140 to 400 kPa (20 - 58 psi). The
manufacturer accepts no liability for
damage caused by excessive water
pressure.
BACK
5
9
10
power supply.
5.
If a grounding terminal is absent from the outlet,
connect a single-core cord (a flexible copper wire of
over 1.6mm in diameter) to the grounding terminal in
the chiller and to a copper plate (over 0.7mm in thick-
ness and 900 cm2 in area) and bury it into the ground
as deep as 75 cm. Never connect the grounding wire to
a water or gas pipe.
6.
There are no user serviceable parts and there are
dangerous voltages present within the unit. Any servi-
cing and installation should be performed by qualified
technicians.
7.
When the plug is disconnected or when the power
is temporarily turned off, please allow a minimum of 5
minutes before re-starting.
8.
The warranty is void if the chiller is modified or al-
tered. Alteration may cause serious flooding, electrical
shock or a fire.
4
3
6
8
15
Publicidad
