SEVERIN KM 3864 Instrucciones De Uso página 12

permitted to play with the
appliance.
∙ Caution: Keep any packaging materials
well away from children – these
materials are a potential source of
danger, e.g. of suffocation.
∙ Every time the appliance is used, the
main body including the power cord as
well as any attachment fitted should
be checked thoroughly for any defects.
Should the appliance, for instance, have
been dropped onto a hard surface, or if
excessive force has been used to pull
the power cord, it must no longer be
used: even invisible damage may have
adverse effects on the operational safety
of the appliance.
∙ Do not allow the appliance or its power
cord to touch hot surfaces or to come
into contact with any heat sources.
∙ Do not put fingers into the feeder chute,
and do not insert any other objects.
∙ After switching off, always wait until the
motor has come to a complete standstill
before opening the appliance. Do not
touch any moving parts.
∙ No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
Before using for the first time
Before using the appliance for the first time,
remove any remaining packaging materials
and stickers, and clean the appliance as
described in the Cleaning and care section.
12
Short-time operation
The appliance is designed to be operated
without interruption for a maximum of 30
seconds, when it should be allowed to cool
down for approximately 3 minutes.
Safety switch
This appliance is equipped with a special
safety switch. The appliance can only be
switched on if the lid is correctly fitted and
the processing bowl properly mounted on
top of the drive unit.
Rotary control
The following settings can be selected:
P The appliance remains switched on at
maximum power as long as the rotary
switch is held in this position.
0 The appliance is switched off.
I Low power
II Maximum power
Operation
Slicing / shredding - Carrots, potatoes
etc.
∙ See fig. I.
∙ Place the bowl onto the drive unit and
turn clockwise to lock, so that the two
triangular symbols
∙ Fit the cutting&shredding disk onto the
drive shaft.
∙ Place the cutting&shredding blade on
the cutting&shredding disk.
Cutting: The blades are facing up
Shredding: The blades are facing down
Note: The disks are protruding from the
bowl.
are aligned.