IPC Mistral-H PW-H101 Instrucciones De Montaje página 25

clothing.
• Do not pull the supply cable or the appliance itself in order to
disconnect the plug from the electric supply.
(For water cleaners rated at less than 3 kW fitted with plug).
As for the protection against electric shock, the H.P.cleaner
belongs to CLASS I.
Failure to observe the above warning frees the manufac-
turer from all responsibility and constitutes negligent use
USING
THE CLEANER
CONTROL PANEL
A - On/off switch
B - Temperature regulator
C - Pressure gauge.
STARTING THE CLEANER
1) Turn on the water supply
tap (fig. 6A).
2) Connect the water cleaner to the mains electricity supply via
the omnipolar switch or by plugging the plug into the socket.
3) Start the cleaner by turning the selector switch to pos. 1 (fig.
8A). Refer to the "Control
!
Warning
The high pressure water jet generates a reaction force in the
lance. Keep a firm grip on the lance handle.
4) Press the trigger on the gun and begin washing.
5) Per il funzionamento dell'idropulitrice con acqua calda, far
riferimento al fascicolo "Pannello Comandi".
!
Warning
In water cleaners with the "Total Stop" system, the motor starts
and stops when the lever on the lance handle is actioned or
released.
!
Danger
Do not block the handle lever
in the delivery position.
IMPORTANT!
To eliminate any impurities
or air bubbles from the wa-
ter circuit we advise starting
the cleaner for the first time
without the lance and letting
the water run out for a few
seconds.
Impurities could block the
nozzle and cause malfun-
ction (fig. 9).
A
ECO
C
Panel".
English
USING THE ACCESSORIES.
The high pressure washer has a nozzle with a flat angle jet for
cleaning large surfaces.
! Warning
Aim the jet from a certain distance to avoid damage caused by
the high pressure.
ROTARY HEAD (optional accessory)
The high pressure washer can be fitted with a head with rotary
nozzle to clean the most stubborn dirt.
!
Danger:
Aim the jet from a certain distance to avoid damage caused by
the high pressure.
OK
Do not aim the jet at people, animals or electrical sockets.
41548
B
USE OF THE DOUBLE LAN-
CE. (fig.10) (if available).
41571
The double lance allows the
operator to select a low or high
pressure jet. The pressure is
FIG. 8
selected with the gun in pos.
1. High pressure: pos. 2. Low
pressure.
REGULATING PRESSURE
AND USING STEAM.
This chapter concerns only
those models provided with
the "pressure regulating" de-
vice. The pressure regulator,
fig. 11, allows the operator to
adjust the working pressure.
When knob C is turned in
an anti-clockwise direction
(B) (minimum), the working
pressure is reduced.
USING COLD WATER
It is suitable for removing light dirt or for rinsing operations on
garden tools, walls, balconies, hard floors in general,etc.
Adjust water pressure according to your needs.
USING "ECO" MODE
In the "ECO" mode, the pressure washer uses temperature up
to 60°C, which offers an efficient use of resources with a positive
impact on the environment.
FIG. 9
- 25 -
FIG. 10
FIG.11