Velleman PEM10D2 Manual Del Usuario página 5

•
Only use the device for its intended purpose. Using the device in an
unauthorised way will void the warranty.
•
Damage caused by disregard of certain guidelines in this manual is
not covered by the warranty and the dealer will not accept
responsibility for any ensuing defects or problems.
•
The user is responsible for the proper connection and functioning of
the device and the follow up of possible alarm outputs. Velleman nv
can not be held responsible for any loss of goods or other damage
caused by neglecting alarm conditions or due to misuse or
malfunctioning of the device.
•
Keep this manual for future reference.
4.
Features
•
Waterproof
•
led indicator for beam alignment
•
tamper switch
•
anti‐fog/dew/rain cover
•
comes with mounting accessories
5.
Overview
Refer to the illustrations on page 2 and 3 of this manual.
A hood
B mounting bracket
C transmitter/receiver lens
D alignment LED
E tamper switch
F vertical alignment bolt
Terminals
1 input voltage input voltage 12 ~ 250V AC or DC (no polarity)
2 input voltage
3 NC
4 NO
5 COM
6 TP1
7 TP2
6.
Installation
•
Determine a location for the system. Avoid direct sunlight on the
transmitter/receiver lens [C] and note that the maximum distance to
the reflector is 10m. Make sure to point towards a flat surface to
which the reflector can easily be mounted. Also keep in mind that
06.12.2010
PEM10D2
output contacts
normally closed between 3 and 5
Normally open between 4 and 5
tamper contact: open when tamper switch is
pressed (cover is closed)
G terminals
H cover
I gland
J mounting bolt
K wall cable hole
L screw (4x)
5
Rev. 01
©Velleman nv