Parts Description; Functional Description; Charging The Unit - Makita PDC1200 Manual De Instrucciones

10. The contained lithium-ion batteries are subject
to the Dangerous Goods Legislation require-
ments.
For commercial transports e.g. by third parties,
forwarding agents, special requirement on pack-
aging and labeling must be observed.
For preparation of the item being shipped, consult-
ing an expert for hazardous material is required.
Please also observe possibly more detailed
national regulations.
Tape or mask off open contacts and pack up the
battery in such a manner that it cannot move
around in the packaging.
11. When disposing the battery, remove it from the
tool and dispose of it in a safe place. Follow
your local regulations relating to disposal of
battery.
12. Use the battery only with the products speci-
fied by Makita. Installing the battery to non-com-
pliant products may result in a fire, excessive heat,
explosion, or leak of electrolyte.
13. If the tool/machine is not used for a long
period of time, the battery must be removed
from the tool.

PARTS DESCRIPTION

► Fig.1
1 Base plate
5 Cord holder
9 Adapters for 36 V
(18 V x 2)
13 Socket of battery
charger
17 Shoulder harness
assembly
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the unit is
switched off before adjusting or checking func-
tion on the unit.

Charging the unit

CAUTION:
After charging is complete, be
sure to remove the power plug of the battery
charger from the AC voltage source, and remove
the socket of the battery charger and attach the
cap of the battery.
2 Battery
6 Adapter pocket
10 Plug of adapter
14 Waist belt
18 Battery stand
14. Keep the battery away from children.
SAVE THESE INSTRUCTIONS.
CAUTION:
Only use genuine Makita batteries.
Use of non-genuine Makita batteries, or batteries that
have been altered, may result in the battery bursting
causing fires, personal injury and damage. It will
also void the Makita warranty for the Makita tool and
charger.
Tips for maintaining maximum
battery life
Charge the battery before completely dis-
1.
charged. Always stop tool/machine operation
and charge the battery when you notice less
tool power.
Never recharge a fully charged battery.
2.
Overcharging shortens the battery service life.
Charge the battery with room temperature at
3.
10 °C - 40 °C (50 °F - 104 °F). Let a hot battery
cool down before charging it.
4. Charge the battery if you do not use it for a
long period (more than six months).
3 Handle
7 Power button
11 Power plug of battery
charger
15 Socket
- -
NOTICE:
The battery charger is intended for
charging MAKITA portable power pack only. Never
use it for other purposes or for other manufactur-
er's batteries.
NOTICE:
When the battery charger is connected
to the unit, the tool or machine does not start. In
this case, remove the battery charger from the
unit.
NOTICE:
If the temperature of the battery
becomes low or high during charging, the
charging may stop. In this case, wait until the bat-
tery becomes ordinary temperature by warming
up or cooling down the battery, and then restart
the charging.
1. Remove the cap of the battery by turning it.
► Fig.2: 1. Cap
2. Align the protrusion on the socket of the battery
charger with the counterpart on the plug of the unit, and
then attach the socket to the plug by turning the socket.
► Fig.3: 1. Protrusion 2. Socket 3. Plug
12 ENGLISH
4 Lock button
8 Plug of battery
12 Battery charger
16 Width adjustment belt
- -