Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INSTRUCTIONS
SAFETY SYMBOLS
This is the safety alert symbol. When you see this symbol on
your pump or in this manual, look for one of the following signal
words and be alert to the potential for personal injury:
warns about hazards that will cause serious
personal injury, death or major property damage if ignored.
warns about hazards that can cause serious
personal injury, death or major property damage if ignored.
warns about hazards that will or can cause minor
personal injury or property damage if ignored.
The word NOTICE indicates special instructions that are
important but not related to hazards.
CALIFORNIA PROPOSITION 65 WARNING
This product and related accessories contain
chemicals known to the State of California to cause cancer,
birth defects or other reproductive harm.
GENERAL SAFETY
1.
Carefully read and follow all safety instructions in this
manual and on the unit itself.
2.
Follow all applicable local and state codes and regulations.
3 .
RISK OF EXPLOSION. HAZARDOUS
PRESSURE. The pump body may explode if used as a
booster pump unless a relief valve capable of passing the
full pump flow at 75 PSI (517 kPa) is installed.
4 .
RISK OF FIRE AND EXPLOSION. CAN CAUSE
SEVERE INJURY, PROPERTY DAMAGE OR DEATH. To avoid
risk of fire and explosion, pump only water with this pump.
Do not use this pump in an atmosphere that might contain
flammable fumes or vapors.
5.
RISK OF BURNS. Never run the pump dry. To
do so can damage internal parts, overheat pump (which can
cause burns to people handling or servicing pump), and will
void warranty.
6.
If water is trapped in the pump during operation it may
turn to steam. Trapped steam can lead to an explosion
and burns. Never run the pump with the outlet closed or
obstructed.
7.
Do not touch an operating motor. Modern motors can
operate at high temperatures. To avoid burns when
servicing the pump, allow it to cool for 20 minutes after
shut-down before handling.
FP324 (07-01-23)
ELECTRICAL SAFETY
RISK OF ELECTRIC SHOCK . CAN SHOCK,
1.
BURN OR KILL. The pump is supplied with a 3-conductor
grounding type cord. Connect only to a properly grounded,
GFCI protected outlet.
2.
Do not lift pump by the electrical cord.
3.
Unplug pump before servicing and disconnect power before
working on pump, motor or tank.
4.
The pump is non-submersible. Keep the motor dry at all
times. Do not wash the motor. Do not immerse. Protect the
motor from wet weather.
5.
If using an extension cord, use only a UL approved indoor/
outdoor, 3-wire, grounding type cord. Do not allow any part
of the cord or the receptacle ends to sit in water or in damp
locations.
6.
Unplug the pump before servicing. To avoid fatal shocks,
proceed as follows if the pump needs servicing.
7.
Disconnect the power to the pump outlet box before pulling
the pump plug. After the plug is pulled, let the pump cool
for 20 minutes before attempting to work on it.
8.
Take extreme care when changing fuses. To reduce the
chance of fatal electrical shock, DO NOT stand in water or
put your finger in the fuse socket.
9.
Ground electrical outlet box.
3
Publicidad
